Make passport wallets by hand

Package surface production: 4 trapezoidal card positions are cut according to the drawing size:

Card pocket dark pocket production: In order to prevent the card in the 2-3-4 card slot from leaking into the lower layer, it is necessary to make trapezoidal dark pockets for 2-3-4 respectively, and the card not leaking part is the size required for the dark pocket: (upper bottom 13 + bottom bottom 20cm) * height 8.5cm, the green part of the picture below is glued to the double-sided tape as a dark pocket on the back of the card package, the stitching is applied from the bottom layer of the card package, and a layer is sewn and then stitched. The layer is finally finished with a 8.5cm ribbon, the size of the card package is the same as the first step, and the card package is partially completed.

(Boarding board) The insert part is made, the double-sided tape on the back of the leather is glued to the ribbon lining, and the 212.5px width ribbon can be used obliquely. As long as the visible part is visible, there is no need to completely affix the lining, and finally the lighter talks. Prevent flash

Outer mobile phone bag making: The back of the wallet is 212.5px from the top 1/4, and the ribbon is used as a dark pocket to sew and then sew.

Part of the banknote package is made using the remaining cross-grain leather on the left side of the card package. As the table ribbon, the double-sided tape is still attached along the edge. The ribbon can be layered with two layers of double-sided tape. The black line is simply sewn. Passport The package part is similarly produced: The passport pack is placed on the lower layer of the banknote pack, and the remaining purple leather material is attached to the ribbon along the side, and the width of 8.5cm can be used.

6

The bottom fabric is fitted and the zipper is sewn: 3 pieces of 8.5*24.5cm ribbon, the glossy side is pasted on the inner layer of the wallet, the double-sided tape sticks the zipper along the side, and then the card package and the receipt (boarding pass) part are The banknotes and passport packs are partially returned, and they are aligned with the four sides of the wallet as much as possible. The double-sided adhesive is good. The diamond is punched and sewn. Note that the key parts are fixed after sewing. The zipper does not contain the upper part of the wallet. Take the boarding pass ticket key, etc.

7

Part of the key ring is made: a hole is punched at a distance of 3cm from the upper end, and the oval double-sided leather that connects the key ring is cut out. After the key ring, the universal glue is folded and folded, the round punching hole, the wheel nail link, and the hand pull is also added. For the aesthetic symmetry, the lower symmetrical part is also decorated with a round nail leather.